Dalapro Medium

€14.95

Content

3 l

10 l

Dalapro Medium is a grey ready-to-use hand putty for many indoor applications. It ensures a nice even surface.

What's in it for you

Ready-to-use paste
Both suitable for joining, flattening and finishing
Good adhesion and filling power
Lightweight
Easy to sand

Dalapro Medium - putty

Dalapro Medium is an all-round grey hand filler for many indoor applications, it ensures a nice even surface.

Description

The filler is a ready-to-use paste, where no more water needs to be added. Its light weight what is also an advantage, allowing you to apply the filler smoothly and making it easy to fill gaps. In short: with this putty, you won't get any sags!

The product is suitable for first filling, joint filling and thin smoothing in both renovation and new construction. The filler is suitable for paper tape embedding.

Dalapro Medium is suitable for smoothing and finishing of:

Drywall, plaster fiber boards, plaster and plaster blocks
Cementations
Structural and decorative plasters
Fiberglass fabrics
Concrete, aerated concrete
Sand-lime brick
Etc.

Key features

Creamy consistency
Good adhesion and filling power
Both suitable for joining, flattening and finishing
Easy to sand
Fine end result

Application method:	Spatula or putty knife
Coverage:	1 l/m²
Gloss level:	Matt
Purpose:	Ceiling, Walls
Base:	Water-based
Interior / exterior:	Interior
Substrate:	Concrete, Fibreglass, Plasterboard, Structural plasters
Area:	Bathroom, Bedroom, Child's room, Hallway, Kitchen, Living room
Characteristics:	1-component, Sustainable packaging
Product type:	Putty

Technical data sheet
Download

How to use Dalapro Medium

A hand filler is easy to apply with a spatula or filler knife. But before you start, make sure you remove any loose or protruding bits on the surface. You can do this with a stabbing knife, possibly using paint stripper, or sometimes a coarse grit sandpaper, depending on what you want to remove. Dirt, dust, grease and moisture can also be removed. As with painting, it is best to start with a cleaned, degreased and dry surface. Berdy Clearline prepares your surface well.

Next, you can get started with your filler. Take some on your filler knife. When you want to level large damages, hold your filler knife slightly flatter. This way you can push the putty well into the small gaps. For smaller blemishes, make the angle between your surface and the filler knife slightly larger (about a 45°). That way, you make a little more use of the straight edge of the knife scraping away the excess putty.

Finishing

After the putty has fully hardened, you can use some sandpaper to get rid of the last irregularities if necessary. Before painting, it is also recommended anyway to go over your filler work again with a fine-grit sandpaper. By the way, apply a primer before painting or wallpapering. That way you will get the best result!

Also interesting

Polyfilla - Snelplamuur

Content: 400 g

Variants from €6.83

From €10.46

Sigma Sigmulto Stucco Matt

Content: 5 l

From €190.45